Stromberg 97 with Push Throttle

Overview

  • Built to original Stromberg blueprint specification, with key improvements.
  • Perfect for your 1949-51 Mercury or Lincoln Zephyr with 'push' linkage
  • Factory-set brass float, made in the USA on original dies
  • Reinforced airhorn lid eliminates leaks
  • A big 97 and all the other correct markings
  • Twin-ball S-jet inlet valve
  • High tech cellulose/nitrile gaskets

Part No. 9510A-LZ

$525.00

Updating Wishlist
525.00

  $

Stromberg 97 with Push Throttle

They’re just the same. But better than ever. A brand new genuine Stromberg 97. And on this model, a different throttle shaft bracket, set up for linkages that push instead of the usual pull from the firewall like some Mercury and Lincoln Zephyr models (please check before ordering). Available only from Stromberg Speed Parts.

Here are the highlights:

  • Super-accurate pressure die-castings from new dies, CNC-machined for a blue-print parts fit. So no oversize screw threads. No mystery parts from previous rebuilds. No problems.
  • An early style cast iron base with stock size – not second-best oversize – throttle shaft. Parkerized and black lacquered just like they used to be.
  • A reinforced air horn casting with extra material around the float bowl lid to eliminate warping and leaks.
  • Stock original (sea level) Stromberg jetting – 0.045 main jets and a Number 65 power valve.
  • 162cfm out of the box (independently verified) measured at 1.5inch Hg (same as they measure 4-bbl carbs).
  • A new brass float, made in USA on original Stromberg dies.

 

  • A specially developed no-stick S-Jet inlet valve.
  • Modern, high-tech, reinforced gaskets. Sorry, no leaks.
  • Stainless steel linkage throughout. Who needs rust? Not us. Our springs are stainless. So is the accelerator pump rod, the throttle linkage, choke plate, lever and more.
  • Beautiful investment cast stainless steel throttle and accelerator pump levers.
  • Correct pale chromate zinc treatment using the original Ford Service Bulletin process.
  • Original-style riveted throttle and choke shafts.
  • Extensive dyno and road tests have proved that it matches or exceeds original spec.

Note: Original hand throttle parts are not included. If you need them, email us, as we can probably find you good used parts.

Remember, like any carburetor, the Genuine Stromberg 97 needs proper installation and tuning for optimum performance. Every 97 comes with full installation instructions and we are working on help with tuning in our Tech Center.

 

Tech Center

Will the new 97 fit my car?

Thinking about a 97? Here are some notes about your manifold stud pattern, carburetor spacing, air cleaner and hood clearance, linkage, choke, fuel lines, distributor vacuum, cfm and more.

HOW TO: Install 9533K Main jets

9533K, main jets, install, remove, swap, tune, 

HOW TO: Install 9594K Power valve

9594K, power valve, install, 9594K-65

HOW TO: Install 69447K manifold gasket 6-pack

How to use our 69447K kit to install or replace your manifold to carburetor gaskets.

HOW TO: Install 9447K Full gasket kit

How to take your Stromberg 97, BIG97, 48, 81 or LZ apart for cleaning, then install our 9447K gasket kit.  

Literature

Stromberg 97 Owner’s Manual

97, carburetor, manual, instructions, guide, install, installation, literature, download, 

Download PDF