TwoStep 2×2 Premium Linkage. 4-3/4in carb spacing


Fits Offenhauser 1090 & 1075 2x2 Regular intake

Fits Edelbrock 1103 2x2 Slingshot intake

Fits Navarro 2x2 Regular intake

Fits Eddie Meyer 2x2 High-rise intake

Fits Thickstun PM-7 High-rise intake

Works with all Stromberg 9141 TwoStep fuel lines (as pictured)

Extended throttle shafts not required

Part No. 9241P


Updating Wishlist


TwoStep 2×2 Premium Linkage. 4-3/4in carb spacing

A premium 2×2 carburetor linkage with rod ends for positive action, die-cast Superlink levers and a stainless steel link rod.

Use on intake manifolds with carburetors 4-3/4 inches apart. If in doubt, simply measure your manifold spacing – throttle shaft to throttle shaft.


Exclusive to Stromberg Speed Parts, this linkage features ‘Snapback’ throttle return springs which virtually disappear from view. Special bolts were developed with a small blind hole, allowing you to insert eg, a hex key, to tighten the lock nut. And opposite threaded rod ends ensure easy adjustment. Just spin the link rod to correct the lever angles.

The linkage comes pre-assembled, installs in just two simple steps and comes with full instructions. Click the other tabs for help with installation and tuning.



TwoStep Linkage Installation Guide

TwoStep, linkage, installation, guide, download, Owner’s, manual, instructions, 3×2, 2×2

Download PDF