TwoStep 2×2 Linkage.
8-5/16in carb spacing


Fits Offenhauser 1080 2x2 intake for 1949-63 Cadillac (8-5/16in spacing)

Fits Eddie Meyer 1932-48 'low-rise' intake for Flathead Ford (8-1/4in spacing)

Fits other intakes with less than 8-5/16 inch carb spacing

Extended throttle shafts not required

Part No. 9250S


Updating Wishlist


TwoStep 2×2 Linkage.
8-5/16in carb spacing

A competitively priced, 2×2 carburetor linkage with clean, traditional looks, die-cast Superlink levers and a stainless steel link rod. Use on intake manifolds with carburetors 8-5/16 inches apart or less. If in doubt, simply measure your manifold spacing – throttle shaft to throttle shaft.

Please note: Photo shows 9242S kit. This kit just puts the carburetors a little closer together.


Exclusive to Stromberg Speed Parts, this linkage features ‘Snapback’ throttle return springs which virtually disappear from view. The swivels are positively fixed by a small e-clip on the back, and the small black set-screws on the front have knurled ends for a strong fix on the stainless rod.

The linkage comes pre-assembled, installs in just two simple steps and comes with full instructions. Click the other tabs for help with installation and tuning.


TwoStep Linkage Installation Guide

TwoStep, linkage, installation, guide, download, Owner’s, manual, instructions, 3×2, 2×2

Download PDF